MIG Welding Machine Aluminum Spool Gun Wire Feed Feeder for HITBOX MIG Welder

Description

MIG Welding Machine Aluminum Spool Gun Wire Feed Feeder for HITBOX MIG Welder
Specification:
Rated Welding Current
CO2:200A
Mixed Gas: 160A
Duty Cycle :35%
Wire Diameter :Mild Steel 0.4-0.8mm
Stainless Steel :0.6-0.8mm
Aluminium :0.6-1.0mm
Wire Speed : 0~16m/min
Spool Cover Diameter :φ102mm
Motor Voltage : DC 24V
Speed Adjust Potentiometer :10kΩ(1kΩ/5kΩ)
Cooling System :Air cooling
Changeable Gun Neck : Straight neck/Goose neck
Connection : Euro-central
Criterion: GB 15579.7-2013
Welding mode: MIG/MAG
Guiding mode: manual
Rated voltage: ≤113V
Rated electrical controlling rate: 24V
How to Use：
1.Switch off welder power, make the Euro-central
connector connect with wire feeder adaptor ,and
tighten threaded collar. Insert plug into receptacle ,
and tighten threaded collar.
2. Installing wire spool
Press the button on the spool cover then open it,
loose the spool cover fixing screw (levo), slide wire
spool to it’s shaft, Adjust nut to make it suitable.
Push wire through guides into wire feeding roll.
Press the trigger after closed the cover, wire feeding
roll make the wire into the gun tube.
3. Adjusting the wire feeding pressure
Turn the pressure adjusting screw clockwise with
hand, the pressure will increase, otherwise it will
decrease.
4. Adjusting the wire feeding speed
Turn the wire feeding speed adjusting knob clockwise, the speed will increase, otherwise it will
decrease.
Packing List:
1X spool gun
（Not included welding stick)