Donut bath bomb mold - mini bath bomb mold.

Description

This plunger style mold was designed to be used by hand, but can be used with a bath bomb press if your press will accept these styles of molds.
This mini-sized donut is a hit in our bath and body store!  To enhance your donut bath bombs, optionally add cupcake sprinkles, body safe glitter or drizzle melted cocoa butter on the top!
The level of bath bomb mix required depends entirely on your recipe, so it may take a few attempts to figure out how much to fill. We like to add a little to the bottom of the donut mold and press down, then loosely fill to the top of the saturn ring. Then add the top of the mold and press down firmly by hand or with a bath bomb press.
Next, clean out the center donut hole with a popsicle stick or other instrument, and then slide the outer ring off. Clean up the saturn ring on the sides of the bomb by smoothing with your hand, and when ready remove the top half.  It may require some gentle tapping on the side of the mold to break the vacuum. Place the bath bomb on a flat surface, then tap the sides to release the other half.
Dimensions of finished bath bomb: approximately 2.5 inches (Diameter) x 1 7/16ths of an inch high, but varies by how much bath bomb mix you use. Weight varies by your unique bath bomb recipe.
Printed with PLA plastic so wash in cold water only, and do not soak as they can retain water.
Colors vary based upon our filament supply and our choosing.
Bath bombs not included.
The picture of the decorated bath bomb represents what you can add to after you make the bath bomb - it does not represent how the bath bomb comes out of the mold.